Pulling some 50 bmg rounds .... Can anyone help out nearby

wolf300H&H

wolf300H&H

CGN Regular
Rating - 100%
105   0   0
Location
Cabin in central Alberta
So just working on a load for my 50 bmg and have decided to pull 220 gr -224 gr loadings .... They were too hot , difficult bolt opening and a good scratch on my nose. Really puts the fear in you for the next trigger squeeze lemme tell ya.

Gonna concentrate around 217 gr of h50 and the 750 amax.

I don't have a bullet puller for this massive of a round and was just wondering if anybody could lend me one or come over and use it. I'm in red deer but travel around a lot.

There's only 7 to pull but that's like $21 bucks of bullets , wrecked if I use pliers or something.

Thanks for reading guys.
 
Do you have access to a lathe or some one who does? It's pretty easy to make a collet that works in a single stage press..........How much full caliber bullet do you have above your case mouth?
 
Ummm. Nope. Sounds cool though. Come to think of it I'll just order a collet for my Rcbs puller from sinclairs maybe tomorrow. Gotta order a 45 cal trimmer body for my Wilson anyhow for an upcoming calibre.
 
Thanks dmay.not necessary now. I placed a couple orders this morning to get the equipment to load for a 45-120 so I just slapped the collet on that order. 10-11 bucks. I'll save 10 with the saved bullets. Lol. Otherwise I would have taken you up on that offer. Good to know though your looking after me. Hehe.
 
You must log in or register to reply here.
Back
Top Bottom