Question about installing the SR 22 short quad rail handguard from Dlask

A

AkHolic

New member
EE Expired
Rating - 100%
1   0   0
Location
Ontario- GTA
Specifically I'm experiencing difficulties with removing the barrel nut from the forearm adapter.
Does anyone know of any online instructions on how do do this instillation, or does anyone have the handguard on their SR 22 that could kindly provide some insight?
 
I installed a dlask on mine as well, I cannot stress enough that in order to get the barrel nut off you're going to need to apply a lot of heat to melt the red locktite that ruger uses. Without doing this its like the two parts are practically welded together. So heat it up evenly with a blow torch until the locktite is melted and then it should just spin right off quite easily.
 
I cooked my nut but only had a mini torch handy.I then wacked by barrel nut with screwdriver/hammer and got lucky cause barrel nut just split in two.The Dlask quadrail is pricey but it sure is nice.Now only if i could find some irons,they,re rare as hounds teeth now.
 
You must log in or register to reply here.
Back
Top Bottom