Rbcs vibratory case tumbler is spinning????

[Brianma65]

The tumbler is spinning in circles until the cord wraps around it. Is this ok or should I bolt it down?

 

[Yukidaruma]

The tumbler is spinning in circles until the cord wraps around it. Is this ok or should I bolt it down?

Are you using it on a level surface?

 

[Jefferson]

just like your girlfriend it has tits, on the bottom of the base that are usually hard rubber or plastic that keep it from spinning,

at least most tumblers that vibrate do : ' )


Jefferson

 

[Brianma65]

Yes it's level, and it has tits, it's sitting on a laminate floor, it spins in a circle , until the cord wraps around it completely , which stops it from moving any further. Maybe it's because the floor is slippery. Maybe I could remove the tits and screw it to the bench?

 

[silverfoxdj]

I'd keep the bench free for loading stuff it fills up fast enough lol

 

[Yukidaruma]

You may be right about the slippery floor surface, try a different type of surface. If that does not work take a look at how it is assembled, maybe out of balance! I would contact RCBS as well and see what they think could be the problem.

 

[mjn]

Too smooth, I had the same problem,put a piece of old carpet underneath and good to go.

 

[mr.e moose]

I have laminate flooring in my reloading room also.What I did was put some rubber toolbox liner under my tumbler.

 

[Brianma65]

Put a piece of rubber mat under it,problem solved thanks..