RCBS hand loader spring dimensions

S

StevenR

New member
Rating - 100%
9   0   0
Location
Woodstock, ON
Was priming tonight and about 300pcs in I felt something hit my foot. Looked down and it was the primer rod. I’d adjusted my grip and apparently the safety gate screw had worked loose and everything fell apart. The compression spring is nowhere to be found. Could someone measure theirs (ID,OD and wire diameter) so I can source a replacement locally rather than wait to order one.

Thank I’m advance.

Steve
 
RCBS hand primer tool. Spring is 1 1/4" long, 10 coils in the length, diameter is 11/32" (1/32 over 5/16 )

I tryed a 5/16 spring with 13 coils in the 1 1/4 length and it worked but felt bad.
 
You must log in or register to reply here.
Back
Top Bottom