RCBS Little Dandy Powder Thrower

[ATOM]

I was looking at one of these for very light loads. Did a search but most of the posts were WRT accuracy. OK, I accept that it's accurate, but how flexible is it?

Let's say I want to throw 3.1 gr of Titegroup. Am I going to wind up with one rotor throwing 3.0 and another throwing 3.3 and nothing in between?

Anybody had any hands-on with this?

Thanks.

 

[Grinch]

You can customize the rotor by buying one that is undersized for the load that you want and carefully open it up with a drill bit of similar diameter until you get what you want.

 

[dogzilla]

I have one and that's exactly what I did, although I used a carbide endmill and just turned it by hand a couple of turns at a time. The bushings aren't hardened so it isn't difficult

 

[ATOM]

Thanks, guys.