Reciever wrench

[Bush Hunter]

Does anyone know where a person might buy one in Canada.
A blueprint would be ok as well as I have access to the tooling to make one.
Kind of sucks for one time use. Any other barrel removal ideas would be appreciated.
Thanks BH

 

[Beater]

for what

 

[millwright]

Ask Hungry about his "Special super cheap" receiver wrench.It's all you really need.

 

[Bush Hunter]

Sorry Gents,
The rifles a 305 poly 2007 vintage. She's a straight shooter stock, but I would like something a little shorter.

 

[phishtapher]

I think this might be Hungry's "Special super cheap" receiver wrench

From here: http://www.canadiangunnutz.com/forum/showthread.php?t=643768

 

[millwright]

Yup thats the super duper receiver wrench. Now ya gotta make a barrel block like those shown.

 

[Repro77]

Thats it, alright! A big wrench from Princess Auto! It took mine apart, and put it back together very nicely.

 

[M14Doctor]

2- 6"x 5/8" steel bolts washers and nuts
1 - 1"x1" square tube 2 feet long with slot at center to fit connector pin retaining pin.
1 - 1"x1" steel key stock, 6 inches long
Drill holes in tubing and key stock for the bolts so you have one each side of receiver.

Done like dinner, now you need a barrel vice

 

[Bush Hunter]

Thanks for the info. I have a few wrenches like that kicking around the shop. As for a barrel vise I machined one a while back. I just need to make aluminum bushings for the 305 barrel. I wasn't sure if anyone had used a normal wrench. As for a clinic, it would be great to go to one but I live in Edmonton and work a rotation shift so getting to one could be a challenge.
Thanks Again, BH