Remington 700 as single shot?

dastt

dastt

CGN Regular
Rating - 100%
34   0   0
I have a new idea for another stock project for an Fclass stock, and I have 9 board feet of quilted maple laying around, just wondering if anyone knows if they sell or make a plate for the round to sit on where the dbm would be? I don't feel like inleting another dbm in this one.

Also if anyone knows any sources for trigger gaurds, I can make pretty much anything work.
 
I know that Sinclair's sells a single shot follower for a Remington 700. Not to sure if they will ship that across the boarder or not. Be worth checking into. Hope that helps you out.
 
Last edited:
Check out ScoreHigh, I'm pretty sure Jerry (mystic) sells them. They are meant to sit on top of the mag follower in the floor plate mags but they have a flat bottom so would only require maybe .5" of an inlet below the action. I'm sure there are pics on the Internet.
 
I will check it out, thanks a lot.

A small inlet inside is no big deal, and I can just bed it in there when I bed the action.


Now to just find a trigger guard.


Also has anyone heard about sps adjustable hardware? Found this while trying to source adjustable LOP and cheek, prices seem right and they will ship to Canada. It'd be nice to find something Canadian, and cheap, total projected cost for the project is $250
 
You must log in or register to reply here.
Back
Top Bottom