Remington 700 Bolt Knob Threading-FINISHED

So I have a LH 700 that I would like to replace the entire bolt handle on with a factory OEM handle. Who in Canada is the best man for the job? It might as well be put on correctly.
 
HOSSONE said:
Looks like i'm the unlucky one and got a void...lol! Its actually quite deep, guessing around .100" or so. Its away from the base so I dont think it will be an issue. I ended up removing the knob on a EDM machine to avoid excess strain on the brazed connection so I will have to put the threads on manually.
Click to expand...

With an EDM!

With feed & speed, you should have burned & threaded at the same time!
5/16"-24tpi.
 
I found an old picture of a rifle with a knob install I did by hand...

700-bolt-handle.jpg
 
TangoKilo said:
DANS40X,

What do you charge to correct the timing issue?
How challenging is it to get a bolt to and from Canada for you to complete the work?

Tk
Click to expand...



Unless said bolt handle is re-worked,radial extraction TIMING is NOT addressed/accomplished.PERIOD.
Moving said handle closer to the receiver does NOT address radial TIMING needed for Primary Extraction.
$135.00 USD for un-molested handles.
any services declined if a SAKO extractor modification was installed.

With the current Cabal's in each country,I have declined importing or exporting "welded machine parts".
 
You must log in or register to reply here.
Back
Top Bottom