remington 7600 and your scope mounts

[ghostntheshell]

Hey folks. I'm looking for advice from anyone with a scoped rem7600. I currently have high look-thru mounts. They have an old "clamp over" style ring that is incredibly fruistrating as it turns the scope when tightening screws. Once I got my scope on (bushnell 3200 elite) I ran out of windage.

Basically I want to know exactly what mounts you guys are using. I don't care if it's a look-thru or not. Thanks guys.

 

[blargon]

Either Talley Light-Weights or weaver rail with Burris Zee rings.

 

[3macs1]

I use leupold one piece base and their std rings on mine.

 

[NB444]

I use leupold one piece base and their std rings on mine.

X2 - Very solid mount with windage adjustment, if needed.

 

[ghostntheshell]

Interesting! Thanks for the responses.

 

[lister]

Weaver one piece base with Weaver see-thru rings with Bushnell 3200.
Once you mount a few hundred scopes with weaver rings, you get used to off-setting the reticle so it pulls in straight when you tighten the ring screws.

 

[ryan32]

weaver on mine works good

 

[wonksy]

I got 1pc Weaver Base w/ Burris Zees ontop of a Leupold VX3 1.5-5x20mm

 

[BAC4]

I have 1 with a Leupold 1 piece base and their rings and 1 with a Weaver base and Burris Z-rings.Both work good. I personally don't care for the see-through rings as I have to lift my head to see through the scope,making a proper cheek weld impossible. Bac4

 

[Freist]

I recently went from kwik-site mounts to leupold one piece base and standard rings on my rem 7600. So far, I feel that I have a better cheek weld then before but I will have to visit my local gun range in May to find out the effects on accuracy.

 

[deadeyes40]

weaver one piece base and burris zee rings.

 

[Cummins4x4]

Leupold dual dovetail 30mm rings and base on a 7615

 

[SuperCub]

I use a Weaver base on mine with some cheapy aluminum weaver type rings. Lightweight and works just fine.

 

[SuperCub]

I found the Leupold 1pc steel base with steel rings to be a bit heavy. My rifle is a carbine, so I wanted to keep it as light as possible.


.

 

[senior]

I use a Weaver base on mine with some cheapy aluminum weaver type rings. Lightweight and works just fine.

I have the same set-up.
Cheap, works fine.
760 Carbine in 308, weaver base, whatever basic rings I had in my drawer & a B&L 1.5-6.

 

[hugh manuell]

I am using Weaver Pivot mounts on my 35 Whelen. Some folks think these tend to lose zero, but mine have held fine for 20 years. Unfortunately, I think they are no longer available new.

Hugh