Remington Model 7 front sight removal

FatCatsDad

CGN Ultra frequent flyer
Rating - 100%
204   0   0
When looking from the rear of the gun towards the front, does the sight get drifted from left to right or right to left for removal.

Front sight assembly needs to be removed as it can be seen in the scope.
 
Crank up the volume on the ocular end a notch or two if it is a variable.
It should disappear.

Changing my setup from a base and medium rings to Talley 1 piece Medium....the only thing I'll see under 4 power is a fuzzy sight.
Scope is too high off center line of bore axis....even with low rings and this EGW base.. still too high....hoping the Talkey 1 piece will get it lower.

Lol, check out my pool noodles...



 
Last edited:
Back
Top Bottom