remington versamax tactical stock change

[docryan61]

I just got a versamax tactical love this thing, I intend to use it for turkey hunting so I like a pistol grip shotgun for turkey hunting you can hold it up with one hand easier while pressing button on my call with the other, here is my question I found on one of the sponsor a mesa tactical pistol grip stock for the versamax so I ordered it but I looked at a few video on youtube on how to install it and one video is talking about having to ordered a bushing that not in the box from mesa.
anybody ever replace the original stock on a versamax how hard was it, did you have to get a special bushing from mesa tactical, thank you for your help.

 

[45CAT]

Following

 

[whatfor]

........ but I looked at a few video on youtube on how to install it and one video is talking about having to ordered a bushing that not in the box from mesa.
anybody ever replace the original stock on a versamax how hard was it, did you have to get a special bushing from mesa tactical, thank you for your help.

The special bushing is for the Mossberg 930 shotgun. The installation for Versa Max is very simple. Read page 8 of the installation manual.

https://www.mesatactical.com/content/47380_urbino_tactical_stock_rev_e-WEB.pdf

 

[docryan61]

ok thank you yes you are right its the only video I found on installation it was for the 930 im glad its not to complicated

 

[docryan61]

ok I got the mesa stock today and I think they sent me a stock for another model it will not fit my versamax at all not even close, here are some pictures of the receiver and both stock the original and the mesa stock can anybody tell me if they sent me the right stock or is it me that cant figure out how to install it,thanks.


this is my versamax receiver


this is the original stock


this is the mesa tactical they sent me


and this is all they sent me with the stock

 

[whatfor]

Looks like it is the right stock. Take one of the plates with the four holes (your choice of sling mounts or none) and fit it over the protruding 4 studs on the stock. Read bottom of page 5 of the manual. It is that simple..

 

[docryan61]

thanks for the info it is the right stock after I posted my message I e mailed mesa and to my surprise got a response in like an hour very good customer support in the first picture of my receiver there a plastic part the just pressure push in the receiver you use a small screwdriver handle to knock it out and the 4 holes are behind it stock is on looked amazing thank again for the help.