Replacement pad for HS precision stock

[buckbrushoutdoors]

So the factory supplied recoil pad on my HS spotter stock is basically a rubber mallet. I've removed it with no issues (epoxied in place) now I need a new pad. Either a limb saver or decellerator pad. Has anyone else done this conversion? And what pad did you choose? I think I'm pretty much stuck with using a grind to fit but I've never done one so any suggestions would be helpful

 

[Buckmastr]

Limbsaver customer service is pretty good. Call them with the dimensions. Those newer air tech pads are pretty effective. But are not grind to fit.

 

[buckbrushoutdoors]

Limbsaver customer service is pretty good. Call them with the dimensions. Those newer air tech pads are pretty effective. But are not grind to fit.

Will do thanks for the suggestion. This 358 is going to have some boot to it

 

[double gun]

I've replaced several with grind to fit decelerators. I never even considered that someone may make a prefit.