Retiming a BLR action

[DillyMac]

I'm searching for some help. My BLR action is currently out of timing and I'm at a loss for instructions on how to have it moving smoothly again.

 

[Boomer]

That's beacause Browning doesn't want you to mess with the inner workings of your BLR, to insructions are not readily available. Send your rifle to a Browning repair center.

 

[bb07]

If I can figure out how to send it I'll send you a pdf copy of the BLR field service manual. Hold on.....

 

[BrotherRockeye]

The BLR field service manual can be downloaded off the net by anyone. No need to send anything.

edit:

Had a buddies 270 BLR for a cleaning/scope mount/sight in, here in the fall. The first round out I thought the safety was on...
I burst out laughing when I read this later "The trigger mechanism has been adjusted at the factory to provide a short, crisp pull"

 

[bb07]

That's even easier

 

[hunter5425]

I have a very simple description by Guntech how to time them Give me a pm with your email and I'll send it to you

 

[gunrunner8]

Two dummy slightly under size pins are needed to do it right and even the best gunsmith might need more
than half dozen attempts. Original pins are tight fit and more than couple of uses will destroy tolerances.
There are two sets of rack and pinion working together, one fine the other coarse so the assembly is tricky....
GR8 2c worth.