RFB initial thoughts, Range report ***JANUARY 31st ammo test at bottom of OP***

How difficult is it to remove enough of the barrel to chuck it in a lathe and thread the end for a small brake? I'm pretty low on the list and don't think I'll have a RFB till sometime in February. :-(
 
How difficult is it to remove enough of the barrel to chuck it in a lathe and thread the end for a small brake? I'm pretty low on the list and don't think I'll have a RFB till sometime in February. :-(

When it's completely field stripped the entire barrel is accessible. The rifle is built around the barrel, which is different.
 
Kel-tec hasn't come out to say its the lacquer. But imagine what steel case 7.62 will do in a 308 chamber in a gun that's known to blow up from such ammo. If I was the distributor I'd be shipping these with a big warning cause from what I have seen I am part of a minority who reads gun manuals and does pre-purchase research.

Imagine when used RFB will be flying around minus the gun manual...
 
Back
Top Bottom