Rifle Wood Cleaning.

Bearhunter, I get what you are saying but don’t necessarily agree. What I want is an original WW1 rifle that is mechanically sound so I can use it. I want all of the components to be made by the original manufacturer and of the original vintage. I want all the metal components to be in good condition, not rusted and pitted. Most of all I want the bolt, receiver and barrel to be original and matching. No FTR replaced and/or restamped parts. But, I don’t want it to look new, I want it to look 100+ years old. Does a 100% original 1918 SMLE exist? Can you prove it’s 100% original. If it was would you ever take it outside? I would say no. I’m just building the next best thing, for me.
 
I have had success with using a steam cleaner for wood and metal. Steam comes out in a stream that has pressure . Wood gets cleaned up but not over cleaned, doesn't lose its look but gets the grease and dirt off. I use raw linseed oil and turpentine at 50 50 mix. Apply and let soak in, apply until wood won't absorb anymore. For metal parts works great as well. Heats metal and pushes all old cosmo out of all areas, spray with G96 and let sit overnight or longer then wipe down.
 
Bearhunter, I get what you are saying but don’t necessarily agree. What I want is an original WW1 rifle that is mechanically sound so I can use it. I want all of the components to be made by the original manufacturer and of the original vintage. I want all the metal components to be in good condition, not rusted and pitted. Most of all I want the bolt, receiver and barrel to be original and matching. No FTR replaced and/or restamped parts. But, I don’t want it to look new, I want it to look 100+ years old. Does a 100% original 1918 SMLE exist? Can you prove it’s 100% original. If it was would you ever take it outside? I would say no. I’m just building the next best thing, for me.

Yes, 100% SMLEs exist.

I wouldn't even try to change your mind about what you want. It's always an individual choice.

Lots of good methods for cleaning stocks the way you would like to see your firearm look like when you're finished.

Just remember, it's also possible to make that rifle have the ''been there, done that" look. I've seen quite a few done that way.

As for FTR's, IMHO you're selling them short but that's me.

Hope it all works for you.
 
Bearhunter, thanks. I think it’ll be a nice piece when it’s done. Part of my reasoning for this project is the rusty POS SMLE that donated the wood is one of the first Enfields I ever bought. Trying to save at least part of it! It was definitely put together from a pile of random parts so it has no historical significance. Nothing against FTR rifles, I just like to collect original ones, though I do have a couple FTRs.
 
Back
Top Bottom