Rimfire Pics...Show em off!!!

Brappp306 said:
Here's my new PPS-50. 30 round stick mag and a 1x32mm Bushnell trophy T-Dot scope. Amazing gun, love it. Find it much better than the 10/22! 300 rounds later and only one jam :)
995159_10151747922041049_867379341_n_zps71611f5c.jpg
[/URL][/IMG]
Click to expand...

How do you like that scope? Mine has been great so far and I've been using it lots, its still on the battery that came with it. Not sure what the battery life on them is. As for the PPS-50 how much did that guy run you?
 
Purchased this yesterday and mounted my scope. Swindlehurst action, Lilja barrel, Jewel trigger, Kelby stock, Time Precision tuner, Kelby rings and Leupold Competition 45X scope



 
Finally took a couple pictures this evening, these are a bit of a contrast to most of the other rimfires above in this thread!

IMO, the purtiest of the cooeys: the trainer (82) with the rear peep site (it has two rear sites on it actually). I've only fired one round out of it and have been meaning to clean up the bore and get it cleaned up a bit.




same rifle, different light, the lumber looks darker/lighter but is somewhere in the middle.
Actually just sold the cooey yesterday...


And, an old winchester model 1906 that was gramp's, it's got a bit of patina on it, it was born in 1925 and can be taken down with one screw above the trigger in about 3-5 seconds and put back together in the same:



Aint seen any of these winchesters in this thread yet, starting to wonder if they are a bit rare?
 
Last edited:
Here's my 93BV in .17hmr. I finally got decent glass in the form of a 2.5-10x44 Viper PST from a member on here. I also really like the Triad pack and DIP bottom metal. Down the road, I'd like to pillar and bed the action, and maybe look into a trigger. For the time being this is just fine though.


This is where I normally shoot, depending on what we've got in the field. On the left is the 100yd target and if you look carefully, in the center you can see an 18"x18" target at 400 painted yellow.
 




Remington 40X Rimfire, single shot, Shilen 20" barrel, 2 oz trigger, MacMillan Stock, Ser. # 0565XXR
From the original 24" barrel the manufacture code would suggest July 1978.
B X L 4200 36X AO scope

Cleaned up the trigger with lighter fluid and air. It breaks cleanly at around 6 oz.
It is going to Dennis after the 22 BR season ends.
 
Last edited:
Here is my krinker plinker. I added the fake selector, and I went 1 step further. I took an airsoft AK mag, took out the guts and mounted a 1022 rotary mag on it. I also added a rubber butt pad on the stock to increase length. Here is a pic of the rifle now.

 
Last edited:
You must log in or register to reply here.
Back
Top Bottom