Rimfire Tacticool Stocks

I have a FS556 and am awaiting additional bits before full assembly. I'm quite pleased with the fabrication and the design; good customer service too. The finish is uniform and clean; any discolouration is from a coat of oil I applied just before taking the pics. Note the hole above the 2 grooves; this is so the 10/22 frame serial number remains visible (quite clever). About the only issue I have is that the rail height on the FS556 is slightly higher than that of a standard quad rail when mated but I think I'll be able to compensate with my sights. Once I'm done, I'll post a full write up with pics. For now, here are a couple of pics of the FS556 on my basement floor (no tactiplinker glamour here):

fs556leftassem2.jpg


fs556leftdisassem.jpg
 
The Krinker should get an honorable mention;

DSC03851.jpg


Although there are a few short comings with them, overall they are quite fun. If I were to build another black 22 right now, I would get Fabsports 556 unit.
 
I would give a vote for the Archangel. It has a very close feel to the AR variants. Mystic is the guy to talk to about this.

Unlike Evos and Nordics, These units aren't quite as "Upgradable" as far as pistol grips and handguards, but for me it was a bit more affordable than going the cheapest route with either of the foremention kits.

000_0011-1.jpg
 
It's either the Nordic kit or the Fabsports one for me...much more $$$ though.

One of mine with the Nordic kit...
DSC02200.sized.jpg


And yes, the open sights do line up...
DSC02198.sized.jpg
 
You must log in or register to reply here.
Back
Top Bottom