Ring adapters

G

Gotrek

CGN Ultra frequent flyer
Rating - 100%
36   0   0
Do they make 30mm to 1" ring adapters/bushings?

Sorry fairly new to scope and rings.

I have a set of rings that are really low and the entire piece is machined as one chunk(both rings and the base are one piece), it's super solid and I really want to use it. Problem is that it is made for a 30mm scope and not a 1 inch scope.
 
Their is such a thing made. Usually thet are brand specific however.
I have never used them for fear of scope damage from them not being concentric or aligned perfectly. Maybe they could be lapped but not that I could see giving good enough results for my liking.
 
I'm attached to the scope. It's not great but it works with my stripper clips :)(very compact) Couldn't find a shorter scope.

It's not a precision rifle by all means but my eyes aren't good And it helps me.

Anyone one know where I could find a set of burris Zee Rings, they used to make a superlow model (discontinued now) but someone may still have them.

The mount I'm less attached too, I just like that it's very strong and well machined And lower then anything else I could find locally.

Edit I found some Weaver rings that are .089" from base to bottom of scope. I guess those are close enough but they don't look that great.
http://www.midwayusa.com/viewproduct/?productnumber=140319
 
Brownell's sell the 30mm-to-1-inch reducers that you are looking for. I have used them and they work well, although not the best looking set-up on a high grade gun. They are well made and work just like the Burris inserts, but without any provision for adjusting the centerline of the scope. I don't consider them a permanent solution just because of their cosmetic appearance, but I'm sure that they would work indefinitely without problems.

John
 
Turns out after measuring (who knew) that a 4.5-6mm height would work fine, which is the average low ring. For some reason this mount looks alot lower.
 
You must log in or register to reply here.
Back
Top Bottom