Rings for NS 522

C

Captain Ron

Member
Rating - 100%
51   0   1
Location
Victoria BV
Thinking of getting a Cabela's caliber specific scope for my new NS 522, good move or bad? :confused:
I also will need to purchase some rings, any suggestions on what to buy? Any advise appreciated. :)
 
Check out the Vortex Crossfire II 4-12x44mm AO BDC reticle scope, I did on the advice of another thread and I was sold. It was actually clearer (in my eyes) than the Vortec Diamondback. I was going to get a 3-9x Prostaff rimfire but the 522 being as accurate as it is could benefit from a little higher magnification. I will have to check out these Hawke rings though, everywhere seems to be sold out of weaver to 3/8" dovetail adapters.
 
I used a set of Warne 7.3 rings in medium height on mine. I can't remember where they came from but had them in my cupboard. I'm using a Simmons 6-18 x40 scope. It's higher than I like off the barrel but lines up perfectly with my eye so for now I will leave it. I plan on switching it out to an Oculus 6-24x50 when I sell a couple of things. This ring height will work great with the 50 mm bell.
Scott...
 
A lot of Chinese rings/bases/scopes are crap, but I found some of the UTG stuff to be OK. Threads don't strip first time you tighten them lol
 
Archer Sam said:
I used a set of Warne 7.3 rings in medium height on mine. I can't remember where they came from but had them in my cupboard. I'm using a Simmons 6-18 x40 scope. It's higher than I like off the barrel but lines up perfectly with my eye so for now I will leave it. I plan on switching it out to an Oculus 6-24x50 when I sell a couple of things. This ring height will work great with the 50 mm bell.
Scott...
Click to expand...
Yes, Warnes 7.3 are also my rings of choice.
 
You must log in or register to reply here.
Back
Top Bottom