Searched but i couldn’t find any key infos. Looking to mount a Razor X 56 on top of a T3X Varmint. Area419 20MOA rail and i want room for Defender flip cap(without sun shade). I want PMR rings, according to the calculator the 1.1 will fit but pass the test by a hair. Anyone with a similar setup and did you go with the 1.10 or 1.26? Thanks in advance.
Rings Height Razor/Tikka
- Thread starter Cafard
- Start date
I went with 1.1 PMR rings. Good clearance, about .200'' between the flip cap and the varmint barrel. That being said if any1 is looking to mount a quality scope on a Tikka action i would check out the Spuhr mount who fit on the dovetails and require no rail. Not much more money in the end for a top quality mount with bubble level.
