You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Rings/Mounts for Anschutz 1700 recommendations needed
- Thread starter grauhanen
- Start date
- Location
- Northeastern Ontario
Leupold rimfire rings. Does the 1710 have a flat top receiver or is it round on top?
I am not sure about the top of the receive as I won't be getting it until next week some time.
I understand the rifle is grooved for 11mm and is also drilled and tapped.
I am not sure about the top of the receive as I won't be getting it until next week some time.
I understand the rifle is grooved for 11mm and is also drilled and tapped.
Assuming its a new rifle, the top has the scalloped machining along the top. The Talley one-peice base/ring setup is what i just ordered for my new 1710 (which just arrived as well!) Talley offered a set that uses the drilled/tapped arrangement, and they also offer a set that can uses the 11mm grooves. DIP offers a rail for the 1710 receiver that fits over top of the scalloping, but i don't know where to get them in Canada.
