Rossi ranch hand sights

AlexG

AlexG

Member
Rating - 100%
90   0   0
Location
Edmonton AB
Hey everyone I recently picked up a Rossi ranch hand in 45LC. I then picked up a full length butt stock from western gun parts in Edmonton ab. Now comes the issue of fixing the sights. With the factory sights it shoots about 12 inches high at 50 yards. I've been told it's a very common issue. So my question is what sights did everyone use to replace the factory ones and where did you buy them. Thanks
 
I used the following from brownell for my 44 mag, and it works perfectly. dead on target at 100M. Thought the rear sights you might have to shim it with some aluminum pop can because the rear dovetail is not to spec.

579-105-332 105322 MARBLE 53W 1/16 WHITE
579-000-164 BULLS EYE LONG SIGHT
 
Try and see if any on a search comes up.
Pretty sure this has been covered on'ear before.

Post your results here when you gain your expectations.
 
AlexG said:
Hey everyone I recently picked up a Rossi ranch hand in 45LC. I then picked up a full length butt stock from western gun parts in Edmonton ab. Now comes the issue of fixing the sights. With the factory sights it shoots about 12 inches high at 50 yards. I've been told it's a very common issue. So my question is what sights did everyone use to replace the factory ones and where did you buy them. Thanks
Click to expand...

On my one, I replaced the front sight with a Marbles .531" w/16th. inch brass bead. I installed an XS rear peep to allow maximum sight radius without having to go to a tang sight. This is the setup that works best fer me, and I've tried 'em all except scopes or red dot sights. I got my sights from Brownells.
View attachment 103144
 
You must log in or register to reply here.
Back
Top Bottom