Ruger bull barrel issues

remus1984

remus1984

Member
Rating - 0%
0   0   0
So I have a dlask 10/22 reciver and my factory ruger bull barrel doesn't quite fit. Has anyone else run into this problem? I email dlask and manage to get a good response just after more info.

The rifle functions fine and the bolt face mates up with the barrel and the extractor, there is just a gap between the reciver and the barrel. Thanks
 
What did dlask say? There should not be a gap there. I would throw it in the freezer, then take a heat gun or hair drier to the receiver and tap the back of the receiver with a rubber mallet to mate it up.
 
Well since the firearm operates and functions properly theysaid it's more of a cosmetic issue vs. Improper function. They seem to think the ruger bull barrel is larger than .920 so that's why it doesn't fit quite right. I do not own a set of calipers unfortunately so I was unable to check. I might just turn around and buy another bull barrel
 
You must log in or register to reply here.
Back
Top Bottom