Had mine free-floated by a gunsmith noted for their stock work.
It's an older 1991 unit that had a "jug-choked" barrel, newer units are supposed to have much better factory barrels.
I've had the following done:
Free floated
Bolt lugs lapped
Barrel replaced with MacLennon match stainless barrel (setup for 20"), contour matched to the original.
Trigger replaced
Receiver drilled and tapped for Farrell rail.
Installed 20 MOA Farrell rail.
Better recoil pad installed (SC-100)
Integral sling loops removed and filled.
Sling studs installed.
I've shot it in F-class off a Harris bipod and a rear bag at distances up to 600 meters with a 4-16x42 Nikon Monarch scope.
It's not my primary F-class rifle, but it works just fine. Freaks out the other competitors with it's minimum length (20") barrel.
Sub-MOA with higher magnification from a rest w/good ammunition.
(In retrospect, I should have paid extra for the 4-16x50, there would be enough brightness/exit pupil to use the full 16x.
You need at least 3mm exit pupil even in full sunlight).