When do you decide to stop reloading brass? I noticed on this last go round that I had a few pieces of 7mm Weatherby brass that were a bit hard to get into my lee primer seater. Like the case head was slightly larger. I measured the belt at being a larger diameter than most of the other cases. Should I be using these again?
safe to use?
- Thread starter ffwd
- Start date
They will probably be fine but it is an indication that your load is too hot. You may also find the primer pocket has stretched and you may feel very little or no resistance when seating a primer. If this is the case, I would dispose of the cases and get fresh one.
