Sako a7 magazine trouble

[HunterKz]

Google says this:

Take a Q tip like you use to clean your ears and push down midway on the left side of the follower as close to the inside wall of the mag as possible until the right side clears the flange then follower and spring should pop out. Reassemble in same manner.

This method doesn't work. It only works when reassembling the magazine (in reverse order). However, if you try to disassemble the magazine this way, the W-shaped spring won't release from its grooves and can be damaged. The spring will then bend at a critical angle and may crack or permanently lose its original shape.

 

[HunterKz]

How to fix the Sako A7 magazine issue: the second and third rounds are misaligned after the first round feeds correctly? The second round gets stuck, its nose is tilted at a 45-degree angle, and feeding is impossible. (See on avatar photo please)
I bought a second magazine for $200, but the problem is the same. I tried different ammo from different manufacturers, but the problem persists.
https://drive.google.com/drive/folders/1vLinr32s9hu3p-IdamEImgygazyZldCe

 

[99Solutions]

I had one bad magazine and ordered a second one. I managed to fix the original one by very slightly bending the feed lips with flat vies grips after comparing it to the one that worked. I discovered it mine only needed the slightest adjustment or it overcorrected. The problem has been solved for about 17 years now. I’m not sure if all yours have the same cause or solution but I hope you guys can get it back into service or else manage to get their importer to send you a replacement.

 

[HunterKz]

Google говорит следующее:

Возьмите ватную палочку, которой вы чистите уши, и надавите на левую сторону подавателя посередине, как можно ближе к внутренней стенке магазина, пока правая сторона не выйдет за фланец. После этого подаватель и пружина должны выскочить. Соберите патроны таким же образом.

Спасибо, но Этот метод не работает.