I went ahead and sanded it down with a small file. Here is the end result:
Now I can close the bolt without rubbing but it is *very* close. If I put a receipt in between I can just slide it in/out with slight rubbing and holding the receipt in place. Bit closer than I'd like but I don't know what else I can do right now. The action at the tang area is now tight to the wood cutout. There isn't really any room to move further back. It seems the stock doesn't have a great fit sadly. Any recommendations from here? Pretty disappointing for a new rifle.
I wld kick that back to the factory for a new stock.
