Savage Mark II FV-SR threaded barrel.

[infamy]

Owning a Mark II FV-SR, which is thread at the end, is the threading of any use?
I can't see a muzzle break being of any use in a 22lr.

Is there anything even available in Canada that can be put on it?

 

[super7]

I don't have much use for it...and the darn nut keeps loosing up without some loctite on it.

 

[infamy]

I have the same issue. I was hoping someone would have recommendations for a decent muzzle flash suppressor, or something that would be neat looking, and double as protection for the barrel crown.

 

[Steiner]

Dlask Arms in Canada has some brakes that you could install.

 

[Doc M]

Is it 1/2"x28tpi? If so, all common AR15 brakes/hiders will fit on the end. A wrap of teflon tape can help tighten the fit too, if you're getting tired of loctite.

-M

 

[Doc M]

(I'd be shocked if it weren't threaded 1/2x28, frankly.)

-M

 

[hoytcanon]

The FV-SR is threaded 1/2" X 28 TPI... don`t sell a brake short on an LR... it does have uses, namely; asthetics, crown protection, balance, and also minute muzzle stabilization... which frankly is a bit of a reach... but with 24X-32X magnification on 100 meter paper, we definitely notice the difference... oh, and did I mention that it looks cool???

Here is an FV-SR that is receiving the Schuler brakes in the photos below it;

 

[infamy]

Do any Canadian shops carry that brake?

Will take a look at what Dlask has

 

[hometownhero]

Do any Canadian shops carry that brake?

I would like to know this as well

 

[hoytcanon]

Ross no longer ships to Canada... there are others that do... but not sure who now...

 

[lone-wolf]

I would probably stick on one of these from dlask

 

[Scott Max Danger]

The FV-SR is threaded 1/2" X 28 TPI... don`t sell a brake short on an LR... it does have uses, namely; asthetics, crown protection, balance, and also minute muzzle stabilization... which frankly is a bit of a reach... but with 24X-32X magnification on 100 meter paper, we definitely notice the difference... oh, and did I mention that it looks cool???

Here is an FV-SR that is receiving the Schuler brakes in the photos below it;

Where did you get these scopes ? the one on the blue rifle is sick looking. How much and what kind of magnification

 

[Moparlover]

find a fake can, [suppressor] they look ok

 

[Epoxy7]

I would probably stick on one of these from dlask

The DLask reworked Levang compensator looks pretty good on a bull barrel rimfire. I haven't noticed any difference in accuracy or POI with it on or off. Although it does seem a little quieter for the shooter since it directs the sound more down range. Mostly it looks good.

 

[lone-wolf]

Although it does seem a little quieter for the shooter since it directs the sound more down range.

Yea, I would use it with the cci quiet rounds.