Savage walking varminter

powdergun

powdergun

CGN Ultra frequent flyer
Rating - 100%
245   0   0
I just got back from the range with my new walking varminter in .223. I wasn't expecting much as it is definately not a high end gun and I'd rank it one small step above an axis.

I was out just to get the scope dialed in an fire a few rounds. After three shots to get it dialed in I took 3 shots and my son took another 3 ( 100 yards ) I was using some left over reloads from another 223. We checked the target and you could lay a nickel over all 6 shots with none of the holes peeking out from under the coin.

We then took a few shots at 200 yards at a plastic milk jug just for kicks and it was dead on. I haven't even started to develop a load for this thing.

As long as it doesn't fall apart I think I'm happy:)
 
That's why I like Savage, they shoot much better than most people can use and cost much less than what a lot of people pay for rifles that look much better but don't shoot any better, probably not as good in most cases. Flame on. ;)
 
I have one in 17 Hornet, shoots nickel size groups at 150 yds, very accurate, great cartridge. I wouldn't hesitate to purchase another Walking Varmiter
 
Barry F said:
What are they worth?
Click to expand...

I am looking at a plastic stock one for about $520, regular laminate stock roughly $650, and the thumb hole laminate stock ones around $700.

I was thinking of getting one chambered in .222, but the ugliness outweighed the possibility that it might be a good shooter. After this range report, I may have to reconsider.

By the way, OP....

:needPics:
 
cTL16WqoZ_HmWbX5ok8.png


I can't get over the looks of it...UGH!

Why is the bolt so long?
 
Sorry for not posting a pic of the groups but I've got an assortment of 50 gr. max loads ready to go and I'll try to post some pics next time out.
 
I've got the thumbhole version in .204. Great rifle, shoots under a half inch with blitz kings no problem.

OP I have to ask. How difficult is the bolt to open on yours after you fire or dry fire? Just the bolt lift, not the sliding. Because mine is considerably more difficult than any other bolt I've had.
 
The bolt lift is a little stiff. The set up does not lend itself to rapid cycling of the action. Also, the bolt handle is a bit thin. I don't feel I could crank on it very hard but thats just an opinion. I bought the gun for a bit of range shooting and the odd varmint hunt if I ever get the time.
 
JRodko said:
I've got the thumbhole version in .204. Great rifle, shoots under a half inch with blitz kings no problem.

OP I have to ask. How difficult is the bolt to open on yours after you fire or dry fire? Just the bolt lift, not the sliding. Because mine is considerably more difficult than any other bolt I've had.
Click to expand...

Yep! That's a Savage. I don't worry too much about mine now, but if you were using it for a young shooter starting out the stiff bolt lift would make it difficult to perform follow up shots.

George
 
powdergun said:
I just got back from the range with my new walking varminter in .223. I wasn't expecting much as it is definately not a high end gun and I'd rank it one small step above an axis.

I was out just to get the scope dialed in an fire a few rounds. After three shots to get it dialed in I took 3 shots and my son took another 3 ( 100 yards ) I was using some left over reloads from another 223. We checked the target and you could lay a nickel over all 6 shots with none of the holes peeking out from under the coin.

We then took a few shots at 200 yards at a plastic milk jug just for kicks and it was dead on. I haven't even started to develop a load for this thing.

As long as it doesn't fall apart I think I'm happy:)
Click to expand...

1:9 or 1:12 barrel twist?
 
You must log in or register to reply here.
Back
Top Bottom