Scope for a cooey 600

[Hillbilly]

What is the largest scope I can put on and still have the bolt handle clear? I found my Bushnell 10x40 to big It a 600 my mistake sorry...on the up side it does shot well with iron sights.

 

[guntech]

I am not familiar with a Cooey 300... what is it? Can you post a picture? What scope base is on it? Higher rings are needed if the scope is too big...

 

[Winnipeg Toymaker]

put on higher rings....

 

[Hillbilly]

600

Its a 600 my mistake sorry Has a fixed one piece side scope mount for a one inch tube.

 

[a j cave]

you are going to have to measure how far from center od rings to top of acrtion. this will give u the size of 1/2 the eye piece. Then start to measure some scopes. Check with some buddies as I am sure u can test fiit a few different scopes till u find what fits. Sorry no easy solution. AJ

 

[Hillbilly]

thanks

Thanks for all the replys I will keep you updated on the results.

 

[guntech]

You have to mount a scope quite high on a Cooey 600 and the mounting base can not go over the ejection port... Cooey 600's eject the shells straight up... they were never meant for a scope...

 

[cyclone]

You have to mount a scope quite high on a Cooey 600 and the mounting base can not go over the ejection port... Cooey 600's eject the shells straight up... they were never meant for a scope...

Hence all the side mounts?

 

[Hillbilly]

Thanks

Thanks for all the advice. Winnipeg Toymaker has sorted me out I will post pictures after I have it set up. If you have a cooey question Winnipeg Toymaker is the guy to ask.