Seven Shot Moore

jpc

CGN Ultra frequent flyer
Rating - 100%
692   0   0
moore11.jpg



My most recent find :)
 
Wasn't cleaned in years-still packed with dirt and crud.
Ejector rod is wood/sb steel--oh well
It is tight and has a shiny bore
Most of the nickle is long gone
Low serial number and not a S&W
 
Sweet find. What famous outlaw carried one of these? Was it Robert Younger? Can't remember...
 
Last edited:
I like the way the cylinder swings out to the side to load.
does yours do that?

That one looks to be in Nice shape and has the longer barrel to!
 
There was an article on the Moore in Guns of the Old West a few years back. The barrel and cylinder swing as one piece, and just barely enough to get a case in and out.
 
Found an old copy of 'Guns of the Old West'. Seems it was Cole Younger's .32 cal. back up gun. The article shows a new box of Navy Arms Co. 32 short rimfire cartridges with it.
To Quote from William Bell in his 2004 article in the same mag mentioned above: "Moore's revolver, which held seven cartridges and looked similar to an 1849 Colt Pocket Model revolver, was produced between 1861 & 1863 and for that time period, had some pretty unique features. It had a single action mechanism like most American revolvers of that period, which required the hammer to be manually cocked for each shot, but was not the usual cap and ball handgun made by Colt, Remington and others. Instead, it chambered the same .32 RF Short self contained cartridge as the Smith & Wesson No.2 Army. Considered adequate for its time, the .32 S&W short had an 80-grain outside lubricated lead bullet that was backed by nine grains of black powder, giving it a velocity of about 700 feet per second (FPS) and a muzzle energy of around 90 foot-pounds. This compares performance-wise to the more modern .25 and .32 caliber automatic pistol cartridges."
Hope this provides you with some useful load data if you decide to fire that beauty. The pics show theirs with a detachable steel rod for ejecting spent cartridges as well.
 
Anyone have a lead as to where I could get the specs on the ejector rod, or does someone have one they could measure for me.
Looks like an easy thing to make (love to replace the wooden one)
 
Anyone have a lead as to where I could get the specs on the ejector rod, or does someone have one they could measure for me.
Looks like an easy thing to make (love to replace the wooden one)
 
Back
Top Bottom