+++++ shadow system pistol +++++

[weimajack]

Hi.-

Any body have experience with these pistols?

Look like a Glock 19.

Trigger is a real s--t.

Do you think a "ghost-ghost 3.5 trigger connector" will fit in this pistol without modofications?

Great thanks for any answer.

 

[Alchemist]

I have one. I’m no expert but I thought the trigger was already upgraded. Apparently their customer service is pretty good/active so if you have a duff one maybe give them a shout? Sorry I can’t help about the other Q, their customer service/Twitter/Facebook or whatever they use for messages seems to be pretty responsive with various questions though.

 

[Wendell]

From what I've heard, they have pretty good customer service.

At Shadow Systems, we stand behind every product we produce.

<https://shadowsystemscorp.com/support/>

CONTACT
US Headquarters:
Shadow Systems LLC
1001 Los Rios Boulevard, Suite 100
Plano, TX 75074 USA

Phone Inquiries:
(469) 458-6808

Customer Service:
support@shadowsystemscorp.com[/I]

<https://shadowsystemscorp.com/>[/QUOTE]

 

[DSG03]

I have one as well. IMO it basically has duty/carry trigger. I’m still breaking mine in but I do have a Timney trigger for it which I’ll install shortly. It’s a 3+ pound trigger assembly that's smooth.

 

[pirate604]

I had a SS and from what I recall the trigger was pretty decent. But I also usually prefer to get good at shooting stock triggers as opposed to gussying pistols up with fancy after market triggers.
But to answer your question, yes, a 3.5# connecter should fit no issues. Its a gen3/4 pattern pistol that uses a gen5 barrel.

 

[TRDJer]

I believe it comes with a 3.5# connector. I put a Timney trigger with a Glock 5.5# dot connector in my DR920 and it is quite nice.

 

[pj551016]

I've tried the stock SS trigger and have to agree that it leaves a lot to be desired. It's Gen3 Glock clone so any aftermarket trigger assemblies for Gen3 should work. Based on experience I'd fault the squishy trigger to trigger bar geometry, and therefore would recommend either Apex trigger assembly or alike (Overwatch, CMC, etc.). I doubt you could fix the trigger with the 3.5lb disconnector, as it typically just lightens the trigger.

PJ

 

[weimajack]

I found Timney Trigger at Wild West (shooting center) for Glock Gen 3 - 4