Shell holder for 9.3 x57 ?

[lyktohunt]

I have a set of Hornady dies that came with a number 2 but should have been a number 1. my question is will a number 3 RCBS shell holder work in the Hornady dies used in a Rockchuker press. It seem s like it should to me as the number 3 is what is used for the 8x57 which is what I plan on reforming into 9.3x57
Anybody out there with experience on that,I would appreciate hearing from you.
Thanks

 

[Why not?]

RCBS #3 is the correct shell holder for the 9.3x57, and will works with your setup.

Be sure to try some Ball C2 powder with the 286 gr bullets....2200+ fps is a cinch with that powder, and very accurate in five rifles I have tried it in.

Ted

 

[lyktohunt]

RCBS #3 is the correct shell holder for the 9.3x57, and will works with your setup.

Be sure to try some Ball C2 powder with the 286 gr bullets....2200+ fps is a cinch with that powder, and very accurate in five rifles I have tried it in.

Ted

Thanks Why Not? for your help and I will try to find that powder, I used to use it in my 3030,s but like most powders I have not seen it around these parts for awhile

 

[burnt_servo]

for my 9.3x62 , when using privy 9.3 brass , I had to open up the inside of the shell holder up a bit so the brass would easily slide in and out ....
I can't remember if the 57 family of cases had a similar sized rim and case head to the 9.3x62 .