Shok Buffers

Exactly, if John Browning wanted one he would have invented one.

Pretty poor statement. There is always room for improvement or upgrades. eg. Stoner didn't think of lefties when he designed the M16 and I have a BCM ambidextrous charging handle installed on my AR-15. Sure, it's not needed but it sure is an improvement on the original design. So back to my original post, not needed but...
 
The standard 1911 spring is 16#. A 18.5# spring might help when firing the gun and reduces the wear on the gun when the slide cycles back but you have to remember that the slide slams forward that much harder too. The reason for installing a Wilson Combat Shok Buffer was to keep the 16# spring. Changing it out every 1000 rds or checking it every time you clean it and you wouldn't have to worry about it breaking apart.

That's a good point I had not considered. I run weaker main springs as well, which is another reason I felt I ought to up the recoil somewhat. I grease my locking lugs too, to cushion them against peening. I grease the whole blinking gun, actually lol
 
Replace your recoil spring every 5,000 rounds and you won't have to worry about premature wear on your slide. If you still decide to use a shock buff, make sure you replace it every 1000 rounds or sooner if needed.
 
I use a shok buffer in a Colt lightweight commander because I only shoot it with full power 230 grain loads and don't want to batter the frame. In my combat commander I don't bother but I do change the recoil spring every 1500 rounds.

I suspect that even casual recreational shooters shoot their handguns far more often than combat troops shoot theirs.

44Bore.
 
Exactly, if John Browning wanted one he would have invented one.

So I guess full length guide rods, beavertail grip safeties, ambi thumb safeties, flat mainspring housings and adjustable sights shouldn't be on a 1911 either, seeing as JMB didn't design the 1911 with them. Foolish statement, but you're right about the shock buffs, they're useless and rank up there with the accuwedge.

TW25B
 
Well actually... the original 1911 that JMB designed and was produced did have a flat MSH. The arched MSH on the 1911A1 was a requested change by the US Army who felt the flat one was causing their cavalrymen to shoot low. ;)

as to the original topic, I have no opinion of shok buffs as I have never seen a reason to use them.
 
So I guess full length guide rods, beavertail grip safeties, ambi thumb safeties, flat mainspring housings and adjustable sights shouldn't be on a 1911 either, seeing as JMB didn't design the 1911 with them. Foolish statement, but you're right about the shock buffs, they're useless and rank up there with the accuwedge.

TW25B

You forgot the magwell and 8rd mags. lol
 
Buffer came with my Norc 1911 I got here on the EE. Gun was set up for use with 45-08 and that's what I'll be running a lot of the time at least while in the bush. Buffer looks pretty battered and not exactly sure how many rounds it's seen. The buffer in this application gives me piece of mind and I'll continue to run one.
 
I had one in my 1911 but found the slide would not lock back with the buff installed. I took it out and have fired thousands of rounds with 15 pound variable recoil springs. Shooting just over major power factor haven't had any issues and don't feel like I am missing something without the shok buff.
 
Back
Top Bottom