Show your reloading benches

[diopter]

Interesting. A couple question.
What is the cylinder with the green masking tape used for?
and the Two drill bits epoxied to rifle case?
Still have some of the 310 dies myself.

 

[kodiakjack]

That's the full length resizer, and plunger. I put it in an arbor press or vise to press the case in, then use the plunger to press it back out. I made a little recessed steel plate with a hole in it so the plunger pops the case out through the hole. My holes didn't line up perfect, so I put a few wraps of tape on it so it shimmed it how I needed.

The drill bits are for cleaning up burrs on flash holes.



What dies do you have for your 310?

 

[diopter]

45acp, 45 lc, .308, 30-06

 

[kodiakjack]

45acp, 45 lc, .308, 30-06

Nice. Been looking for a set of 303 for my dad.

 

[Extended Power]

Here is my new reloading room.
I would have liked to have removed the carpet, but no extra money after buying the benches, and tool chest.
Is it going to be a huge issue with carpet?

 

[diopter]

Spilled powder and primers will be a pain on carpet.

 

[Extended Power]

Yeah...and I'm a complete noob to reloading. My wife's uncle let me reload 10 rounds for his 44mag. He just talked me through it, and let me do everything.
Got me hooked instantly.

I will probably try to get the reloading arm, and another base plate, as I didn't like unbolting the press, and installing the powder loader.
Then I could mount the second base further back on the bench....

I know.....I just don't have an extra grand right now to have the carpet removed, and new flooring put down.

 

[diopter]

This may help.
http://www.staples.ca/en/Staples-Me...product_SS2001863_2-CA_1_20001?akamai-feo=off

 

[Extended Power]

That's a good idea.
Thank you!

 

[aubie97]

I know.....I just don't have an extra grand right now to have the carpet removed, and new flooring put down.

Or buy a couple of sheets of strand board and put it on top of the carpet.

 

[fingers284]

Add a small lip to the counter top edge. prevents a lot of powder migration and brass roll off.

 

[bruinsmaniac]

starting to run out of room all ready.

[/url][/img]



table was framed up with 4x4s and 2x6s then topped and edged with 3/4 inch oak plywood, it is rock solid.

i can't read your recipe for 7mm rem mag

 

[corney]

Just a suggestion, get a better power bar and clean up those power cables and contain your powder and primers.

God may sort it out?

 

[corney]

Awesome equipment!

 

[RonR]

Not a reloading bench but a press stand. What I use for a bench is small so I put this together. Portable and me being south paw I couldn't vision a good location to permanently attach the press.

FWIW
Regards
Ronr

 

[Polar_Hunter]

Portable and compact,,,,

https://youtu.be/Qbh5x8ld_Bk

 

[The Outsider]

Here's mine.....

 

[6MT]

…….

 

[The Outsider]

USA Fender Stratocasters with aftermarket pickups.

My hunting rifles are in the safe in the other room, along with my powder all locked up behind security doors.

 

[Superbrad]

^^^^ I like that outsider..... working in a similar concept myself....