captainmike
CGN Regular
- Location
- GVA- fraser valley BC
It appears that many need to review the storage regs for powder!
yes You've got it
75$ each +tx+shipping
very strong no play ,,,,,love them
http://inlinefabrication.com/products/ultramount-for-lee-breech-lock-classic-cast-press
just be carefull to order the right mount for your press each base plate is dedicated to a brand and model with the right bolt patern
Some great ideas on hereHere's mine. Canadian tire cabinet with bench built over it. Bench top is 1.5" plywood with oak veneer. The two parts cabinets are great for storing bullets,tools required for case prep, dies etc. Pretty cost effective.
![]()
![]()
Way too clean!Some great ideas on hereHere's mine. Canadian tire cabinet with bench built over it. Bench top is 1.5" plywood with oak veneer. The two parts cabinets are great for storing bullets,tools required for case prep, dies etc. Pretty cost effective.
![]()
![]()
What's on the floor..been looking for something to cover cement and allow chairs to roll easily..
Your Correct! The chair doesn't move that easily but had to get something down so i didn't tear the sh!t out of the floor. Let me know if you guys has found something better. It's usually not quite that clean, this picture was taken just after i re-finished it.looks like diamond plate foam pads like the pads they sell for kids that interlock. unless it's really thin i don't suspect it's conducive to chairs rolling easily.