SKS magazine reducing capacity methot.

[weimajack]

Anybody know where I can find pictures for SKS reducing capacity method to 5 shots?

 

[Bratwurst]

Just google "SKS magazine" and "SKS magazine pin" and there are pictures

 

[stevey3737]

the easiest way would be to drill a small hole where you want your pin and load 5 rounds then stick a small bit or something into the hole until it touches the bullet rest this will give you the length of your pin needed to stop follower, then just tack it inside bam all done and if you didnt want to do that to all of them you will now know how far down the follower sits when loaded you can then tack a pin to the follower inside then no weld showing

 

[Jake1911]

Put a long rivet through the follower and trim it until you can just push 5 under the bolt

 

[weimajack]

Thank you gang, it's exactly what I need.

 

[bearhunter]

Degrease the magazine on the inside and fill it to the proper level with fiberglass resin. Let it harden and you're set to go.

 

[The Kurgan]

A clever idea, bearhunter.

 

[The Kurgan]

Tack weld a small piece of barstock to the follower arm. Grind it down until you can comfortably fit 5 rounds. It's a clean non-destructive method.

.

 

[jstin]

Here are pictures of different ways they were pinned. Click on picture to enlarge.

https://ibb.co/album/ieoSdv

 

[inawoods90]

Does anyone know where the tutorial is for trimming the actual magazine down so it is flush to the stock? Those look so cool.

 

[DaveyG]

Tack weld a small piece of barstock to the follower arm. Grind it down until you can comfortably fit 5 rounds. It's a clean non-destructive method.

View attachment 503180.

I like this method best