SKS small pin!

[johndeeretimex]

Hello everyone I am looking for where I can buy or get a small pin for the gas chamber on the sks. This pin is used to hold in the wooded stock in place on the gas chamber and i was wondering where i could get a replacement one for it?

thanks

Mark

 

[Curtton]

Hello everyone I am looking for where I can buy or get a small pin for the gas chamber on the sks. This pin is used to hold in the wooded stock in place on the gas chamber and i was wondering where i could get a replacement one for it?

thanks

Mark

use a regular nail from your hardware store .

 

[GilesG]

use a regular nail from your hardware store .

+1

Get the correct diameter nail, and it will hold just fine in addition to being able to push out.

 

[kphebert]

i used a rivet because it was easier to flatten down the ends.

 

[johndeeretimex]

wow i would have never have thought of that! THANKS!

 

[johndeeretimex]

As i was looking for a good size nail to use for the pin on the sks gas chamder I thought of using a drill bit instead! All I would need to do is to find the one that would fit nice in there. It would not be hard to find since there are numbers of sizes out there to use from! I will try to see what works and report back to everyone!