Soft loads for M&P40

NorthernPF

NorthernPF

Regular
Rating - 100%
9   0   1
Location
Ramore, Ontario
Hey Guys!!

I'm looking for some soft loads for a M&P40 for PPC.

Will most likely be loading with lead 180gr Truncated cone but I really want to try some Truncated 180gr AIM bullets which are copper plated aswell.

Any recepies are greatly appreciated.

Eric
 
3.8-4.0 grains Titegroup with a cast 175/180 slug is just ducky. I've went lower in powder charge than this, but it resulted in blackened cases and more smoke.:)

CCI 500 small pistol primer with c.o.l. around 1.130 ish. Runs well in M&P 40.
 
I'm currently building a load with the 180gr aim bullets for my M&P .40.. I'm using WSP primers and bullseye powder..Being copper plated I was told by the supplier to drop the charge by about 10%

So it seems to like 4.9 grains of Bullseye,,don't know if it's soft as I find the M&P snappy to start with,,no signs of being to hot.. ( 4.9 is the starting point for bullseye with regular 180gr bullets)
 
You must log in or register to reply here.
Back
Top Bottom