Sooooo I bought an XL 650....

[Ryan500]

Well after sizing a few hundred brass on my single stage for
10mm I decided to go for it. I bought a 650 says 223 on the box sooooo what all parts do I need to swap it over to 10mm? I picked up the conversion box while I was there. I have dies. Bought a tool head. What else do I need? Or am I covered?

 

[Melnibonean]

You bought a 650 set up for .223 from the factory along with a caliber conversion kit and dies for a 10mm? If you plan on using different toolheads for the .223 and the 10mm, I suggest you buy another powder dispenser in order to have one per already set toolhead and a toolhead stand to hold the toolhead you're not using nice and upright and stable.

Dillon toohead stand part #: 22055
Powder meadure part#: 20782

Did you get a casefeeder as well? If you did, you'll need a plate for small rifle and another for large pistol

Small rifle part #:21074
Large pistol part#: 21072

Don't forget when swapping from .223 to 10mm to change out the primer magazine (from Small primer to Large primer), rotary primer disk (from S to L), and primer seater. These came with your 650 already.

 

[Ryan500]

Holy man these things are quite the operation to get going lol. Gonna be a long night but I think I have all the parts I need other than a powder
Dispenser for the second tool head and stand.

 

[Ryan500]

Yeah if anyone near cold lake knows how to setup one of these pm me. I'll buy beer. I can figure it out but I bet someone who runs one already can save me re-doing it lol.