Sorry but searching the forums is time consuming and irritating. Vz Question...

ShotgunNut

ShotgunNut

CGN frequent flyer
EE Expired
Rating - 100%
12   0   0
Location
Vancouver Island BC Canada
I was up the mountain this fine new years day shooting my CSA VZ and the stock became loose. There is a threaded "lock ring", for lack of a better term, what is the trick to fasten this thing tight enough so that my stock tube doesn't come loose again? I don't want to screw the tube in as far as it will go because the AR butt will end up canted and thats a no no...

I suppose tightening just the ring itself is what I want but what tool to use?
 
Hold the stock, hammer and flat head screw driver or a pair of modified vice grip C-clamps. Mine is as tight as it can go and the stock isn't canted. You just have to hold it while you tighten. Use a rag if you pick the hammer and screw driver so you don't mark up the finish. Mine came loose once. After that it never happened again.
 
Mumbles Marble Mouth said:
Hold the stock, hammer and flat head screw driver or a pair of modified vice grip C-clamps. Mine is as tight as it can go and the stock isn't canted. You just have to hold it while you tighten. Use a rag if you pick the hammer and screw driver so you don't mark up the finish. Mine came loose once. After that it never happened again.
Click to expand...

Thanks, that's a good DIY method. It seemed to work. I think I got it solid again.
 
You must log in or register to reply here.
Back
Top Bottom