Source for a moon clip holder for Alfa Project 9mm?

B

BabySeal

CGN Ultra frequent flyer
Rating - 100%
225   0   0
Location
BC
Does anybody know where in Canada I can find a moon clip holder for an Alfa Project 9mm revolver?

This is the post and clip on a belt loop that will carry 6 round reloads on moon clips.

There are lots of manufacturers out there. But I can't source any in country.

Thanks!
 
I also tried to look for this but honestly I have no luck finding any magnetic moonclip holder for the 6 shot 9mm moonclip. Double Alpha has the one for 8 shots moonclip but I don't think it will work... I am thinking about DIY by replacing the current magnet with a different round magnet. If there is one that works out there I will sure give it a try.

There is an US company has these:

http://www.revolversupply.com/moon-clip-holders/

but you will need to import them from US.


Btw, is there a non-leather holster for Alfa Proj?
 
Bladetech makes some plastic double moon clip holders in different calibers including 9mm.
I used to use them in competition.

Should be fairly easy to get from any bladetech dealer.
 
A Alfa is darn near an external match for the S&W K frame gun. So holsters that fit the same barrel length K frame guns should work well with the Alfa of the same barrel length. Or at most you may need to cut away a few small bits of the plastic.

The moon clip holders may not be as easily a match. The Alfa uses a slightly smaller hole than the 9mm S&W guns. Measure your moonclips and email the makers of the K frame options if you're looking at a center post style holder to confirm that they'll work. But any outside pouch or sprung U shaped holders would work.
 
You must log in or register to reply here.
Back
Top Bottom