Speaking of magnums--7 STW

I have had about the same experience as Bill. Several customers were not happy with the velocity from shorter factory barrels. The STW has worked the best with 28 inch or longer barrels.
 
7rm

Leeper said:
Well, there you go; plainly, not everyone is disappointed! This is an example of a situation where the increased capacity can pay off. With the very slow burning Retumbo, the Rem Mag case will likely not hold enough to generate decent velocity with the 140 grain bullet because it won't develop enough pressure. The use of a slightly faster powder will get the pressure up; along with the velocity. Because of the shorter pressure curve the velocity will not be equal and I doubt one could get much over 3300 with a 140 from a 7 Remington at reasonable pressures. I have seen guys exceed 3400 with 140s from a 7mm Weatherby but I don't think the pressure was really reasonable! Regards, Bill.

Bill is dead on with this post, i have a custom 7RM he built i bought off of a fellow gunnut and i have done alot of testing with 140-160gr bullets and the best i could come up with in terms of velocity in a 24'' tube is 3300fps with H4831 with a 140gr and 3150 with a 160gr using Retumbo both loads happen to be very accurate, i contribute that to Bill's fine workmanship.
 
Back
Top Bottom