speed feed stock question...

[pointandshoot]

hey all, i just picked up a speed feed stock for my grizzly. went to put it on the gun and it was missing the bolt. the bolt that came with the gun is a bit too short to be used with the speed feed stock. so the million dollar question is does any know what length of bolt and thread pitch i need to make this work? by the way its the non p/g with the 2 shell carriers on either side. thanks in advance

 

[999]

have a speed feed stock bolt right here,1/4 x 28 thread and 10 3/16 long also has two 1"dia x1/16 thick washers.

 

[pointandshoot]

thanks so much 999....i know what i'm doing tomorrow...errr....today morning. i doubt the hardware store will have anything like that....the hunt continues.

 

[999]

If you get stuck finding one let me know I have a spare I can part with.

 

[RePete]

1/4" Fine threaded rod (cut to length) and NyLoc nuts work well.