Spent primer catcher

[jamcam1999]

I am looking for a primer catcher for an older Echo press, similar to the older Pacific and Lyman Spartan presses. Any help would be appreciated.
At one time, Echo, ( EC Herkner) made presses for Pacific, RCBS, CH.
I have a newer RCBS primer catcher but it doesn't fit properly and many primers fall through the open areas.
i have also looked at the 3D printed catchers but they are close to $50 by the time they are shipped from the USA.
Thanks in advance, Jack

 

[zuke]

Try plastercine to fill the gap's. I sold my old JR 3 and went to LEE press's

 

[diopter]

I bought one from CH4D for an old C press of theirs. Of course there were numerous changes over the years and I had to grind quite a bit off the insides of the U channel to get a better fit against the press. Rest of opening was covered by adhesive backed copper tape which is thicker than alum tape.

Recently ordered an Ergo Handle From Inline Fabrication. Handle thread is 1/2-20 Same as RCBS Junior3 SS.

 

[diopter]

Received the roller handle today. Balance point is still too far forward for the old CH press linkage. so I still have to tie up the handle in the up position, But it feels nice.

 

[Auggie Doggie]

I just use the basement floor.

Auggie D.

 

[sail32]

I tape a plastic bag around my press and throw it out afterwards.

 

[stampede]

I just use the basement floor.

Auggie D.

Me too.

Some will always get loose and it take the same amount of time to sweep up 300 as it take to sweep up 3.