Stainless AR Mags by Creative Products for CANADA!!

Armedsask said:
Using a lance, would it not be impossible to remove the followers?
Click to expand...
A rather extreme measure for cleaning the magazines, isn't it?
 
Larry (C Products),

Sounds like a good product and it looks like you've created a bit of interest here. I'm looking forward to your announcement of when they're ready and who the Canadian distributor will be.

Cheers,

O'Kelly's Boys
 
JR at The Shooting Edge 403 720-4867 has placed his initial order for the C Products blocked 5 round stainless steel 30 round magazines. He is also ordered other springs and kits. We are very excited and proud to have JR representing our product in Canada. Product should be at his store within the next 2 weeks.

Larry
C Products
 
Mags

Just notify us when and where they will be available?

I don't care how they are pinned as long as I can buy a couple of them at a reasonable price. I have had lots of different kinds of mags over the years plastic, stainless and others, I just want to try these out.

I am looking for an original waffle mag for an AR 15 or M16 for my collection. I saw one in The Black Rifle book, I like how they were made and have always wanted one.

For the Mini 14 guys:
Did you know that the plastic stripper clips, and guides the Canadians Forces use with the C7 mags, work on Mini 14 mags?
 
I just ordered one from TSE. I'll try it out before buying more. I like the finish and the fact that they're stainless, but I'm not sure about not being able to dissassmble it. We'll see.
 
Last edited:
These mags look AWESOME...

I think I'll have to place a second order before long...

FYI, both P&D in Edmonton and Target Sports in Toronto have large shipments of the mags enroute...
 
I just got my mags today.. .they look and feel very nice compared to my Aluminum ones. I did notice a slight coating of rust on the CS srpings but i've been told that that is normal and does not affect performance. The anti-tilt followers work flawlessly and do not bind up at all even if i push down on one side of the follower. I can't wait to put these to the test. i will be taking out the floor plates and replacing them with the magpul ranger plates, I hope they fit.
 
DMeNTED said:
How far are they lanced?

I can remove the followers from my mags that are pinned in the same location with a rivet...
Click to expand...

You can generally do that with normal followers that will tilt in order to get past the rivet or obstruction. I believe these mags from with magpul style anti-tilt followers that will not allow them to get past the lance.
 
You must log in or register to reply here.
Back
Top Bottom