Steiner OTAL-A Offset Aiming Lasers-Advanced

mildot

mildot

CGN Ultra frequent flyer
Rating - 100%
276   0   1
Just wondering if there are any out there in the "wild, and if some end users can chime about performance and "bang for the buck" I know we are pretty limited up here for stuff like a PRQ.

6mq3pqG.jpg


I really wanted this, LOL

JuIyQqx.png
 
Last edited:
I have seen them floating around. I found one used like 4 years ago but I sold it. The unit works as intended, its just a class 1 laser. I don't know what else there is to say about it.

I would recommend looking at Holosun's laser offerings as they are more readily available and are "good enough".
 
PesTo said:
I have seen them floating around. I found one used like 4 years ago but I sold it. The unit works as intended, its just a class 1 laser. I don't know what else there is to say about it.

I would recommend looking at Holosun's laser offerings as they are more readily available and are "good enough".
Click to expand...

Thanks, just wondering? though if the Holosun laser/IR is controlled like the Steiner Dbal out of the US, I really don't have any use for the IR function.
 
I would look into Holosun. The OTAL-C is only available in red, which isn't very good for visiblity. Green lasers are better, however there are two different types: direct drive and DPSS. Steiner uses DPSS for most of their green lasers except for the DBAL-A4, and Holosun uses direct drive. Direct drive is better in Canada because it has a wider operational temperature range, whereas DPSS lasers begin to struggle when the temperature drops to near freezing.
 
PesTo said:
I would look into Holosun. The OTAL-C is only available in red, which isn't very good for visiblity. Green lasers are better, however there are two different types: direct drive and DPSS. Steiner uses DPSS for most of their green lasers except for the DBAL-A4, and Holosun uses direct drive. Direct drive is better in Canada because it has a wider operational temperature range, whereas DPSS lasers begin to struggle when the temperature drops to near freezing.
Click to expand...

Took your advice so, I'm currently looking at these 2 models;
LS321G is milled from aluminum;
LE321G is titanium

With that said the Ti has a slightly "lower" profile? and I believe may have the option of a white light?
Cost is very reasonable and pretty close, with only a slight increase in the LE model?

Any experience with either or care to add anything?
Thanks
 
You must log in or register to reply here.
Back
Top Bottom