Suggestions for a custom 454 casull mold

[Freyr_255]

So I'm now the proud owner of both a Super Redhawk and Rossi Puma in 454 casull. What I'm planning on doing is getting a custom mold made in the ~350 gr range and was just wondering if anyone had suggestions based on experience with loading this cartridge.(every little detail helps out )

Wondering mostly about overall profile, length, and meplat width. I'm going more for a flat point with gas a check in the heaviest practical weight that will feed in both my revolver and levergun(as this is my new bush gun and I'm going to try and get an ATC for the SRH).

Thanks!

 

[ben hunchak]

I'd check with Northman999 on this site, he had an excellent 340 gr. mold made for him by Accurate molds in the USA, I made the bullets from that mold and it is one of the finest molds I've ever used. The only other maker that i can recommend is LBT molds in USA, this is mainly because of the excellent designs of V. Smith, his WFN and LFN styles are used by Garrett and Buffalo Bore for their heavy duty factory ammo.
There are many great mold makers out there but these two prolly have the best designs of "heavy hitters" that I think you are looking for.

 

[Freyr_255]

Excellent and thanks for the info. I'll do some browsing on LBT's site as I was planning on using accurate molds.

I do recall reading some postings by Northman999 on this and was kind of hoping he'd chime in.