absolutely ... and boiling water will remove a variety of other corrosive salts like sweat etc AND existing oil that traps grit and grime! And of course it will heat the metal to a point where it is so hot - it dries almost immediately. THEN a light lubrication when the metal is warm does a lot! Works great on semi -auto pistols and it is the "wunder treatment" for gummed up .22'sor boiling water if corrosive ammo had been used
... snip ... Look how many old rifles are around from the early 1900s and the majority are rust free. The oil used in their early life was almost surely, 3 in 1, or maybe Singer Sewing Machine oil! So what more can all the high priced conditioners with the fancy names do?
I can't get the least bit excited about all the various lubricants out there.
As far as I'm concerned most of the hype is just advertising. How many of these high priced, small bottles of various synthetic lubricants is just rebottled automotive oil?
I grew up in the depression years of the 1930s in the boondocks of northern Canada where we all lived on wild game, year around. I was too young to start with to be in on the hunting, but older brothers, with big rifle and 22 kept a large family well supplied with a good variety of wild game, big and small. One big rifle shot corrosive ammunition on a steady diet, but it never collected any rust throughout its entire life.
The 22 rifle that added so much variety to the diet sits in my basement locker and it never collected a bit of rust, ever, in spite of having been fed some corrosive ammunition in its early life.
Both rifles were out in extremely severe cold, as well as the wet and humid seasons.
They were sometimes cleaned with kerosene, or boiling water if corrosive ammo had been used and always lubricated with the one type of general purpose oil that was available in every country store, the little flat can of "3 in 1" oil.
Look how many old rifles are around from the early 1900s and the majority are rust free. The oil used in their early life was almost surely, 3 in 1, or maybe Singer Sewing Machine oil!
So what more can all the high priced conditioners with the fancy names do?
I've been using Frog Lube exclusively lately. A lot of people knocking it had me reconsidering.. Not anymore. I know this wasn't a lab test, but it sure reaffirms my belief that it works, and works well. And BTW, it is a great cleaner as well.
I was given an old over/under a couple of years ago. It had some junk inside the bores. I thought I'd never get it cleaned, nothing worked (G96, remington, Hoppes). First time I used Frog Lube, I was amazed. I'm sold on it and will continue to use it. It's not expensive, it's non toxic, it doesn't have a bad odour, and it just plain works.
I use Sea Foam Deep Creep for de-gunking old guns. The stuff contains alox which is a great friction reducer,as well as good ole' kerosene. My regular gun care lube for automatics is Militec-1, which I fortify with a dash of Z-Max engine treatment.
My general all around lube & protectant is Jet Lube 12/34 which both cleans and protects my guns and will stay fluid to -50 degrees. I use this stuff to keep all of my electrical connections corrosion free in my vehicles,boats and home. This product is the best all round cleaner/lube I've ever used & have never had any problems with it. Like Deep Creep,it is a great de-gunker, but is proven around marine environments. It's the darling of the Shipyard for those that know.![]()
I am surprised Kroil didn't do better against rust.....we use Aero-kroil at work and is almost magic when it comes to rusted bolts?
G96 Original....smells alot......but I find the smell intoxicating....usually wipe my rifles down with it unless I run out....luv that stuff.....as far as smell....animals will catch human scent just as quick as oil scent....hunt the wind....




























