Suppressor sights holster

[Moonbeam]

I recently acquired a Dan Wesson Discretion 1911 9mm. It comes with suppressor sights on and had the bottom rail.

I have a hard time finding a holster for it.
Any suggestions?

Thanks

https://photos.app.goo.gl/rAHf1dpJrH5cGJdq8

 

[marshall]

This might work , it is a Uncle Micks with a 1911 with standard novak sights 5 in.
It is simple , 30.oo or so , and about 5/16" of clearence. If it was a hit tight, a heat gun will adjust these.

 

[marshall]

Now that I look at your picture again, I forgot about the rail, so that one would not work, unless you wanted to to remake it. Try amazon.ca, I hate to suggest that.

 

[Moonbeam]

Thanks I actually looked at them at cabelas today, sight is still too long. They are friggin gigantic... might have to change em out.

 

[JohnnyP636]

Not the same pistol but I recently had the same issue, I added a red dot and suppressor height sights to my pistol and it would not fit my holsters properly after because the front sight was a little to high.

I looked at a few options, but in the end I just bought true co witness height sights, that were slightly taller then an standard set but not as tall as a suppressor height set. And that worked out perfectly for me

 

[kthomas]

Just change out the sights.

It's not like suppressor height sights are providing any advantage. They arguably don't even provide any advantage even when used with a suppressor.

 

[Greenhorse six]

Solely Canadian.
I haven't used any of their stuff , but , have heard only good things about them , and I see they make a holster for the 1911 with rail .
You should email them if its big enough for taller sights.

 

[Moonbeam]

Thanks I’ll check em out!